cecotec Mambo 11090 - OPERATION; Assembly of the jar; Assembly of the hinged lid; Assembly of accessory holder and fixing bracket

56
ESPAÑOL
Spatula
Instruction manual
App manual
- Clean the jar and other accessories thoroughly with hot water, detergent and a
non-abrasive sponge.
- Place the food processor on a at, stable surface. Keep a distance of at least 110 mm
between the power socket and the wall, furniture, etc. and your food processor.
- Use a damp cloth to clean the main body and wipe it dry.
Warning
Do not place the food processor on any surface that it is not heat-resistant.
3. OPERATION
Assembly of the jar
- Place the jar in the main body, matching the mark on the jar with the front of the main
body, if it is not correctly positioned and you try to start cooking, the display will show the
warning A2. Fig. 2
- There are capacity markings on the side of the jar. The maximum usable capacity of the jar
is 2.3L when using the food processor at speed 0 and 1.8L when using the food processor
at a speed between 1 and 10 or with one of the preset functions.
Assembly of the hinged lid
- Place the lid on the jar, matching the markings on the jar and the lid, press the lid around
the rim of the jar and turn the lid clockwise to secure the lid on the jar. If the cover is not
correctly tted when the speed is other than 0, the A1 warning will appear on the display.
Fig. 3
- When you open the lid, you have the possibility to leave it in the folding position, just turn
the lid counterclockwise until it is xed in the holder, this way you can open the lid without
removing it completely. Fig. 4
Assembly of accessory holder and xing bracket
- Make sure that the accessory holder has the sealing gasket properly installed. When
installing it on the jar you must take into account that the bracket has a certain position,
make sure that it ts correctly. Fig. 5
- Hold and install the accessory holder making sure that it is correctly tted and turn it
clockwise. Fig. 6
- Install the xing bracket to the bottom of the jar and turn it clockwise to attach the
accessory holder to the jar. Fig. 7
04341/04342_Mambo 11090/Habana_IM_YV_01220506.indd 5604341/04342_Mambo 11090/Habana_IM_YV_01220506.indd 56 9/5/22 15:029/5/22 15:02