cecotec Mambo 11090 - TROUBLESHOOTING; Warning codes

66
ESPAÑOL
7. TROUBLESHOOTING
Warning code Description Possible cause Possible solution
A1 warning Locking system. The jar or the lid are
not xed properly.
Re-assemble the jar and
lid, make sure all the parts
are assembled properly and
tightly and try operating it
again.
A2 warning The jar is
incorrectly
positioned
The jar is not in its
correct position or
connection of the
temperature sensor
at the jar base is
damaged.
Re-assemble the jar and
make sure it is xed properly.
A3 warning Content
exceeded.
There is too much food
inside the jar.
Remove some food from
inside the jar or cut the food
to smaller pieces and restart
the food processor.
A4 warning The
temperature is
too high.
There is no or very little
food in the jar and the
set temperature is too
high for too much time.
Add food in the jar.
A5 warning Motor
temperature is
too high.
The food processor has
been running too long
with too much food.
Stop using the food processor
and allow it to cool down
before operating it again.
A7 warning The change in
speed could
not be done
successfully.
Speed change between
low level (1-5) and
high level (6-10) was
blocked.
Remove the jar, turn the xing
bracket manually and place
the jar again in place. Restart
de food processor.
A8 warning Wrong NTC
sensor reading.
The temperature
sensor is not working
properly.
Contact the ocial Technical
Support Service of Cecotec.
04341/04342_Mambo 11090/Habana_IM_YV_01220506.indd 6604341/04342_Mambo 11090/Habana_IM_YV_01220506.indd 66 9/5/22 15:029/5/22 15:02