Cellofoam PERMAPORT XPRESS - Mounting Hardware and Tools; Mounting Hardware; Tools Required

- 4 -
• Stop the engine as soon as the Watercraft is on the Xpress; do not allow engine to run
while out of the water. Do not start the engine while the watercraft is on the Xpress .
Refer to Watercraft owner’s manual for further details.
Mounting Hardware
The Permaport
®
Xpress is best mounted at the front; side mounting is possible but is not
optimal
The standard hardware is suitable for both side and front mounting the Xpress to both fixed
and floating docks. In the case of extremely rough water or unusual conditions there may be
additional or alternative parts required.
It is advisable that this port be installed by a professional dock builder. Failure to mount the
port in accordance with the manufacturer’s instructions will invalidate the warranty.
Tools required
The Xpress port has been designed to be installed with the minimum amount of assembly
and requiring only basic tools.
Note: It is essential that any electrical tools used outdoors be protected by adequate GFCI
protection. We recommend that only hand or battery operated tools be used in close
proximity to water.
• 3/4” Wrench or Long Reach Socket and Ratchet Drive (Preferred)
• Drill and 5/16” Drill Bit
• Wrench or Socket and Ratchet Drive to suit
selected dock hardware.
• For a fixed dock installation, the vertical support
poles need to be driven into the lake bed, it is
recommended that at least a manual fence post
driver be utilized for this purpose.