Cellularline U-COM 8R - Speed Dial Settings; Channel Setting; Unit Language; Audio Equalizer

13
9.2.1 Speed dial
Assign phone numbers for speed dialing to make a phone call quickly.
9.2.2 Channel Setting (Default: channel 1)
If the Open Mesh communication experiences interference because other
groups are also using the channel 1 (default), change the channel. You can
select one of 1 to 9 channels.
9.2.3 Unit Language
You can select the device language. The selected language is maintained
even when the headset is rebooted
9.2.4 Audio Equalizer (Default: O)
You can use the Audio Equalizer to increase/decrease the decibel level of
dierent frequency ranges of audio.
• Balance will adjust all of the frequency ranges to be the same volume
level (0 dB).
• Bass Boost will increase the bass range of audio (20 Hz - 250 Hz).
• Mid Boost will increase the mid range of audio (250 Hz - 4 kHz).
• Treble Boost will increase the high range of audio (4 kHz - 20 kHz).
9.2.5 VOX Phone (Default: Enable)
If this feature is enabled, you can answer incoming calls by voice. When you
hear a ringtone for an incoming call, you can answer the phone by saying a
word such as “Hello” loudly or by blowing air into the microphone. VOX phone
is temporarily disabled if you are connected to intercom. If this feature is
disabled, you have to tap the PHONE button to answer an incoming call.
9.2.6 VOX Sensitivity (Default: 3)
VOX sensitivity can be adjusted depending on your riding environment.
Level 5 is the highest sensitivity setting and level 1 is the lowest.
9.2.7 Intercom-Audio Overlay Sensitivity (Default: 3)
The music and GPS volume will be lowered to play in the background if
you talk over the intercom Mesh while the overlaid audio is playing. You
can adjust the intercom Mesh sensitivity to activate this background
audio mode. Level 1 has the lowest sensitivity and level 5 has the highest
sensitivity.
Note: If your voice is not louder than the sensitivity of the selected level, the
overlaid audio will not be lowered.
9.2.8 Audio Overlay Volume Management (Default: Disable)
The music and GPS overlaid audio reduces in volume whenever there is an
ongoing intercom Mesh conversation. If Audio Overlay Volume Management
is enabled, the volume level of the overlaid audio will not be reduced during
an intercom Mesh conversation.
9.2.9 HD Voice (Default: Enable)
HD Voice allows you to communicate in high-denition during phone calls.
This feature increases the quality so that the audio will be crisp and clear
during phone call conversations.
Note:
• Refer to the manufacturer of your Bluetooth
®
device that will be connected
to the headset to see if it supports HD Voice.
9.2.10 Smart Volume Control (Default: Disable)
Enabling Smart Volume Control automatically changes the level of the
speakers volume based on the level of the environment noise. You can
enable it by setting the sensitivity to low, medium or high.
9.2.11 Sidetone (Default: Disable)
Sidetone is audible feedback of your own voice. It helps you to naturally
speak at the correct level according to varying helmet noise conditions. If
this feature is enabled, you can hear what you are speaking during a phone
call.
9.2.12 Advanced Noise Control™ (Default: Enable)
When Advanced Noise Control is enabled, the background noise is reduced
during an intercom conversation. When it is disabled, the background noise
is mixed with your voice during intercom.