CEN-TECH 60431 User Manual

Page 11
For technical questions, please call 1-800-444-3353.
Item 60431
SAFETYOPERATIONMAINTENANCE SPECIFICATIONS
Troubleshooting
P
roblem
P
ossible
C
auses
Likely Solutions
Likely Solutions
Ammeter display
reads maximum.
Defective battery.
Check or replace battery.
No ammeter reading.
1.
Battery not connected.
2.
No power to charger.
3.
Battery cables not making connection.
4.
Two-amp charge rate being used.
Two-amp charge rate being used.
1.
Connect battery to charger. Ammeter will
have no reading until battery attached.
2.
Check power and cable outlet connections.
3.
Clean battery cables and reset cable clamps.
4.
None, meter will not indicate at this rate.
Charging current
not to full output.
1.
Battery is partially charged.
2.
Defective battery, will not
hold full charge.
1.
Continue charging battery.
2.
Check and/or replace battery.
Ammeter needle
moves up to full
charge, then drops
to zero. Makes
“clicking” noise.
1.
Reversed battery connections.
2.
Battery is completely dead.
3.
Defective battery.
4.
Charger is resetting itself
after circuit overload.
5.
Circuit breaker is cycling.
Circuit breaker is cycling.
1.
Double-check connection polarity.
If
wrong, shut
off charger and correct
cable lead connections.
2.
Continue charging battery.
Charger
will
continue to reset itself until
the battery reaches a chargeable level.
3.
Check and/or replace battery.
4.
Wait until Charger automatically resets itself.
5.
May be the wrong switch position.
May be the wrong switch position.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Record
P
roduct’s Serial Number Here:
Note:
If product has no serial number,
If product has no serial number,
record
month and year of purchase instead.
Note:
Internal parts are not user
Internal parts are not user
-
serviceable
and are not available.

CEN-TECH 60431 Specifications

General

Brand	CEN-TECH
Model	60431
Category	Battery Charger
Language	English