To Next PageTo Next Page
Need help?Do you have a question about the Central Pneumatic 35245 and is the answer not in the manual?
General| Speed | 12, 000 RPM |
|---|---|
| Air Inlet | 1/4 inch NPT |
| Average Air Pressure | 90 PSI |
| Orbit Diameter | 3/16 inches |
| Pad Size | 6 inch |
Maintain a clean, well-lit work area, keep children away, and store equipment properly.
Wear appropriate PPE, dress properly, do not force the tool, and handle cords carefully.
Keep tools sharp, clean, and lubricated; inspect hoses and cords for damage.
Remove keys, avoid unintentional starting, stay alert, and check for damaged parts.
Use correct parts, avoid alcohol/drugs, drain compressor, and heed capacity ratings.
Step-by-step guide for converting the tool for use as a sander.
Procedure for selecting and installing a drill bit into the chuck.
Steps for connecting the sander/drill to an air compressor.
Proper setup, frequent lubrication with pneumatic tool oil, and air supply considerations.
Instructions for marking, drilling, and securing material during drilling.
Guidance on sanding techniques, grit selection, and pattern.
A detailed list of all components with item numbers and descriptions.
Visual representation of how the parts fit together for assembly.
