Page 11For technical questions, please call 1-800-444-3353.Item 60328
NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of
this manual including all text under subheadings therein before set up or use of
this product.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained
within this manual. Improper adjustment can result in tool failure or other serious hazards.
Workpiece and Work Area Setup
1. Before spraying, mask nearby
objects not being sprayed and lay
cloths (not included) on floors.
2. Prepare workpiece according to
paint manufacturer’s directions.
Compressor Setup
1. Insert Power Cord plug into grounded outlet.
2. Connect one end of Air Hose to
Air Outlet of Compressor.
Note: Use this Compressor only with
Airbrushes; do not use this Compressor with
any other type of painting equipment.
Airbrush Setup
IMPORTANT: Only use paints
designed for use with an Airbrush.
Note: Proper paint mixture is essential.
Follow manufacturer’s directions. Most paints
will spray easily if they are thinned properly.
1. Thin paint according to manufacturer’s
directions and mix thoroughly.
2. Carefully strain paint through a paint strainer.
3. Fill Jar to no more than 3/4 full.
4. Thread Lid onto Jar.
5. Gently push Lid Fitting into
Color Stem on Airbrush.
Note: The Jar is held in place
with friction, not threading.
6. Connect Air Hose to Air Inlet.
7. Test the consistency by spraying
on a piece of scrap material.
To Next Page
Loading...
