Page 15For technical questions, please call 1-800-444-3353.Item 60328
NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
SAFETYOPERATIONMAINTENANCE SETUP
Cleaning and Lubrication
1. Empty Jar and clean it with solvent.
2. Turn on Compressor and
connect the Airbrush.
3. Fill Jar with solvent and spray it through
the Airbrush into a container. Once
Jar is empty, repeat the process until
the solvent comes out clean.
4. Disconnect Airbrush from Compressor.
5. Point Airbrush into spent solvent
container and depress Trigger again
to make sure no air remains.
6. Remove Nozzle and Needle and soak them
in solvent until clean. Use old toothbrush
and toothpicks to remove any paint.
CAUTION: Do not immerse Airbrush.
Note: Do not use metal objects to
clean Nozzle to prevent damage to
passages. If Needle becomes bent, have
it replaced by a qualified technician.
7. Use solvent to wipe down Airbrush body.
8. Lubricate Airbrush after cleaning.
A non-silicon oil or a light lubricant may be
used on threaded connections before storing.
Solvent Disposal
After cleaning, dispose of cleaning solvent according to solvent
manufacturer’s directions and local hazardous waste standards.
Storage
Store Airbrush in a dry, secure area out of reach of children.
To Next Page
Loading...
