Never short circuit the battery and do not try to recharge the
batteries with power supply units other than that supplied with the
product, or by Centurion Systems
Make sure that the earthing system is correctly constructed, and that
all metal parts of the system are suitably earthed
Safety devices must be fitted to the installation to guard against
mechanical movement risks, such as crushing, dragging and
shearing
It is recommended that at least one warning indicator light be fitted
to every system
Always fit the warning signs visibly to the inside and outside of the
gate
The installer must explain and demonstrate the manual operation of
the gate in case of an emergency, and must hand the User Guide
over to the user
Explain these safety instructions to all persons authorized to use this
gate, and be sure that they understand the hazards associated with
automated gates
Do not leave packing materials (plastic, polystyrene, etc.) within
reach of children as such materials are potential sources of danger
Dispose of all waste products like packaging materials, worn out
batteries, etc. according to local regulations
Always check the obstruction detection system, and safety devices for
correct operation
Centurion Systems does not accept any liability caused by improper
use of the product, or for use other than that for which the
automated system was intended
This product was designed and built strictly for the use indicated in
this documentation. Any other use, not expressly indicated here,
could compromise the service life/operation of the product and/or
be a source of danger
page 4
To Next Page
