page 4
It is important that the Theft-resistant Cage is properly fitted as per the
instructions given and that a suitable lock is fitted. Please note that a lock is
not supplied in this kit. Centurion Systems recommends using an insurance-
approved padlock with a minimum throat width of 30mm. Refer to the
illustration below.
2. Remove side vents, retaining nuts and
washers. Fit a bracket to each of the
left hand side retaining studs.
1. IMPORTANT! For magnetic
origin operator models,
relocate gate magnet as
close as possible to operator
cover and reset gate Limits.
30mm
FIGURE 2. MINIMUM THROAT SIZE OF REQUIRED PADLOCK
To Next Page
Loading...
