© Cesab 12 – 11 T Code(s): 841, 842, 843
Repair manual: Brake system/Wheels C3000 Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
12.7.4 Disassembling the castor wheel cradle
1. Raise the forks.
2. Remove the inspection cover.
3. Loosen the spring fasteners.
4. Loosen the bracket for the castor wheel mounting.
5. Lift the drive unit so that the cradle is free.
Install in reverse order.
12.8 Spring replacement
12.8.1 Removing springs
1. Loosen the upper locking nuts.
2. Lift the drive unit so that the springs are released from the upper bracket.
3. Loosen the lower locking nut on the spring that is to be changed.
Note:
The spring is pre-tensioned, take care when loosening the lower locking nut.
12.8.2 Fitting the spring
1. Place a block under the spring bolt so that the spring screw is held in
place.
2. Fit the spring with the lower locking nut and washer.
Use a short sleeve in order to screw the lower locking nut tight whilst
pressing the spring together.
3. Screw down the lower locking nut so that the distance between the edge
of the washer and the top of the screw is 15 mm.
4. Make sure that the springs are sitting correctly in the upper fasteners
when the drive part is lowered.
5. Screw the upper locking nuts tightly.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
