3. Hold the Program-Master for ca 1 second in the reading field of the locking device to end
the “authorise mode.
The following signal appears:
1x long green and 1x long beep
The “authorise mode” will end automatically after 5 seconds. Die new authorisations
remain stored.
All locking media, which were held in the reading field, are now authorised to open this locking
device.
A locking media can be deleted from a locking device only with the same Program-Master
with which it was authorised.
Troubleshooting:
Signalling Reason Solution
During step 1:
The program-Master could be read but is
not authorised for this locking device.
Authorise the Program-Master.
Note that you cannot authorise
any Program-Master for the V-
NET devices.
During step 2:
a) The locking media was already
authorised with another Program-Master
or via the OMEGA Client software.
b) Instead of a locking media, a master
media was held in the reading field.
a) Locking media can only be authorised
with a Program-Master or via the
software.
b) Use a locking media.
Page 16 of 39
Signalling of OMEGA FLEX Locking devices
2 Signalling while using the master media
To Next Page
Loading...
