2.12 Deactivating block mode
Required master media:
l Block-Master
The Program-Master must first be authorised for the locking device on which it is to be
used
Procedure:
1. Hold the Block-Master before the reading field of the locking device.
After ca. 2 second, the following signal appears:
2x short green and 2x short beep
2. Remove the Block-Master from the reading field of the locking device.
The blocking mode is now deactivated. An access with an authorised locking media is now possible
again.
Troubleshooting:
Signalling Reason Solution
A higher-priority opening mode is cur
rently active
Deactivate the
opening mode with higher priority.
The Block-Master is not authorised. Authorise the
Block-Master
Page 24 of 39
Signalling of OMEGA FLEX Locking devices
2 Signalling while using the master media
To Next Page
Loading...
