142
MAINTENANCE
Brake uid change
Complete brake system uid replacement should be performed only by trained service personnel. Have your
dealer replace the following components during periodic maintenance, or when they are damaged or leaking:
• Replace the seals every two (2) years.
• Replace the brake hoses every four (4) years.
Brake light switch operation
The brake light switch is activated by foot brake pedal pressure, and is properly working when the brake
light comes on just as braking takes eect. Check that the switch assembly or the electrical circuit is working
properly in case of brake light failure.
Control Cables
Inspection and lubrication
Inspect throttle and brake cables frequently. Lubricate the inner cable and the cable ends. Replace damaged
cables when they are discovered. Submersion of the vehicle may cause cables to corrode or stick. If the
cables do not operate smoothly, ask your dealer to replace them.
NOTE:
Recommended lubricant: SAE 10W-30 or a commercially available cable lubricant.