57
CONTROLS AND FEATURES
Low Beam / High Beam Switch -
9
High Beam is selected when the switch is in this position.
Low Beam is selected when the switch is in this position.
Main Light Switch -
10
The main light switch consists of 3 positions:
Headlights and tail lights ‘ON’ when the switch is in this
position.
Headlights ‘OFF’ and tail lights ‘ON’ when the switch is in
this position.
● Head lights and tail lights are ‘OFF’ when the switch is in
this position.
NOTE:
Ignition key must be turned to ‘ON’ before operating head lights.
CAUTION
Do not use the headlights with the engine turned o for more
than 15 minutes. The battery may discharge to a point that the
starter motor will not operate properly. If this should happen,
remove the battery and recharge it.
To Next Page
Loading...
Need help?
General
