10. Lighting, Instruments, Switches
Water Temperature Transducer
Warning:
Be careful not to get scalded and do not place
flammables nearby.
Warning
¾ Coolant must reach the switch thread, and the
depth from vessel bottom to sensor top should
be over 40mm.
¾ Keep liquid temperature for three minutes
before measuring, and do not raise
temperature sharply.
¾ The thermometer should not contact the vessel
bottom.
Disassembly:
Remove right side panel (→2-7)
Disconnect and remove transducer.
Put the transducer into a vessel with coolant, slowly
heat up the liquid and measure the transducer
resistance.
Temperature Resistance
50℃ 154± 16Ω
88℃ 52 ±4Ω
100℃ 27 ±4Ω
120℃ 16±4Ω
Transducer out of range: →Replace
Install transducer
Connect water temperature transducer connector.
Fill coolant and discharge air
Reverse the removal procedure for installation of
plastic parts and seat.
10-12
To Next Page
Loading...