3. Checks & Adjustment
Master Cylinder
<Fluid level>
Check the brake fluid level
When the brake fluid level is near to the lower limit line, check
master cylinder, brake hoses and joints for leakage. Remove the
two mounting screws on fluid reservoir cap.
Remove the cap, add DOT3 or DOT4 brake liquid till the upper
limit line.
·Do not mix with dust or water when adding brake fluid.
·Use only the recommended of brake fluid
to avoid chemical reaction.
·Brake fluid may cause damages to the surface of the
plastic and rubber parts.
Keep the fluid away from these parts.
·Slightly turn the handlebar left and right till the master
cylinder is in horizontal, then remove the fluid reservoir cap.
Brake Disc, Brake Pad
< Wear of brake pad>
Check the brake pad wears from the mark as indicated.
Replace the brake pad if the wear has reached position of wear
limit trough.
Note
The brake pad must be replaced with a whole set.
Checking and replacing the brake disc
Front brake disc thickness: ≤2.5 mm →Replace
Rear brake disc: ≤6.5 mm →Replace
Min. limited thickness of the front brake disc: 2.5mm
Min. limited thickness of the rear brake disc: 6.5mm
Change the Brake Fluid
< Changing Brake Fluid>
Change the brake fluid once every year.
3-6
To Next Page
Loading...