User's Manual
32
F. Suspend Mode
The Power Management function must not be set to disabled to enable this
function. If the system runs in Standby mode and the Suspend timer expires, all
devices regulated by power management will shut off and the CPU speed will be
0 MHz.
G. HDD Power Down
The Power Management function must not be set to disabled to enable this
function. When the HDD idle time has elapsed, BIOS sends a command to the
hard disk to turn off the motor. Set a time between 1 and 15 to indicate time required
to wait before the hard drive enters a power saving mode. Some old hard drives
may not support this function.
H. Soft-Off by PWR-BTTN
When set to Delay 4 Sec., this function allows the power button to put the system
in Suspend, a power saving mode. See Section 2-4 for operation instructions of
the over-ride power button operation wich puts the system in Suspend mode.
When set to Instant-Off the Soft-Off by PWR-BTTN function is disabled and the
computer turns completely off when the power button is pressed.
I. Power On By Ring
When enabled, a modem that receives a ring signal will wake up the system from
soft off and green mode. You should connect the modem to the COM port
and turn on the resume event in green mode.
J. Wake Up On LAN
Enable this selection to use the Wake Up On LAN function discussed in Section
2-4 of this manual.
K. Resume By Alarm
When enabled, this setting allows the system to turn back on at a designated
time of the month. User must designate date of month and time of day. This
function is only available when using an ATX power supply and the Software
Power-Off function to turn off the computer. See the Software Power-Off Control
in Section 2-4 of this manual for instructions.
To Next Page
Loading...
