7
F.058-B/MODEL 20/SEPT. 2000
• This machine is designed and safeguarded for ONE PERSON operation. NEVER operate the cutter with more than
one person.
• Safety is the responsibility of the user of this machine. Use good judgement and common sense when working
with and around this machine.
• READ and understand all instructions thoroughly before using the cutter. If questions still remain, call your
Authorized Challenge Dealer - fingers and hands are too valuable to risk experimentation.
• Only trained and authorized persons should operate the cutter.
• DO NOT ALTER SAFETY MECHANISMS, they are for your protection and should not be altered or removed. Severe
lacerations or dismemberment could result.
• DISCONNECT POWER before cleaning, lubricating, servicing or making adjustments not requiring power. Turn the
main disconnect switch to the off position and disconnect the power plug, see Disconnect Procedure below.
• Be sure the cutter is properly grounded.
• Be sure there is sufficient power to operate the cutter properly.
• Observe all caution plates mounted on this cutter.
• Keep foreign objects off table and away from cutter blade.
• BE EXTREMELY CAREFUL when handling and changing the cutter knife. Severe lacerations or dismemberment
could result from careless handling procedures. Dispose of worn out knives properly.
• Keep the floor around the cutter free of trim, debris, oil and grease.
• When replacing hydraulic parts, loosen the connections slowly to release pressure. Never loosen connections
with the machine running.
• If the cutter sounds or operates unusually, turn it off and consult the troubleshooting section of this manual. If the
problem cannot be corrected, have it checked by a qualified service person.
• CRUSH HAZARD, keep hand and fingers from under the clamp when clamping paper. Use Jogging Aid to load
paper, and use the backgauge to push paper out before unloading. DO NOT REACH UNDER THE KNIFE AND CLAMP
AREA!
SAFETY PRECAUTIONS
This safety symbol means CAUTION/WARNING - PERSONAL SAFETY INSTRUCTION. Read the
instructions because it has to do with safety. Failure to comply with the following instructions
may result in personal injury.
For maximum safety and to prevent unauthorized
use, turn the power switch to the off position and
disconnect the power /power cord whenever ad-
justing, lubricating, or making repairs to the ma-
chine.
CAUTION: POWER LOCK-OUT PROCEDURE
(fig. 1)
NOTICE: UNSUPPORTED PRODUCT!
NO TECHNICAL SUPPORT AVAILABLE!
NO REPAIR PARTS AVAILABLE!
To Next Page
Loading...
