23
Withouta properly installed safetyreversal
system, persons (particularly small children)
could be SERIOUSLY INJURED or KILLED by a
closing garage door.
• Incorrect adjustment ofgarage door travel
limits will interfere with proper operation of
safetyreversal system.
• After ANY adjustments are made, the safety
reversal system MUSTbe tested.Door
MUST reverse on contactwith 1-1/2" (3.8
cm) high object(or 2x4 laid flat) on floor.
To preventdamage to vehicles, be sure fully
open door provides adequate clearance.
INTRODUCTION
Your garage door opener isdesigned with
electronic controls to make setup and
adjustments easy.The adjustments allowyou
to program where the door will stop in the
open (UP) and close (DOWN) position. The
electronic controls sense the amountof force
required to open and close the door. The
force is adjusted automatically when you
program the travel.
NOTE: If anything interferes with the door’s
upward travel it will stop. If anything interferes
with the door’s downward travel, it will reverse.
To watch a short instructional video on
programming your new garage door opener
use your smartphone to read the QR Code
below:
PROGRAMMING BUTTONS
The programming buttons are located on the
leftside panel of the garage door opener and
are used to program the travel.
UP Button
Adjustment
Button
DOWN Button
PROGRAMMING BUTTONS
Adjustments
To Next Page
Loading...
