Chamberlain 8587 - Remote Control Management; Program Remotes and Keypads via Door Control; Program Remote via Opener Learn Button

30
Your remote control has been programmed at the factory to operate with your garage dooropener.
Older LiftMaster remote controls are NOTcompatible, see page 35 for compatible accessories. Programming can be done through the door control or the learn button the garage door opener. To program
additional accessories refer to the instructions provided with the accessory or visit www.liftmaster.com.Ifyour vehicle is equipped with a Homelink
®
, you may require an external adapter depending on the
make, model, and year ofyour vehicle.Visitwww.homelink.com for additional information.
TO ADD, REPROGRAM,OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL
1 Pressthe navigation button
below "MENU" to view the
Features menu.
2 Use the navigation buttons
to scroll to "PROGRAM".
press
to continue.
3 Select"REMOTE"or
"KEYPAD" to program from
the program menu.
TO REMOTE
press to continue.
4 Remote Control:
Press the button on the remote control thatyou wish to operate your
garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on
the keyless entry keypad. Then press the ENTERbutton.
OR
The garage door opener lightswill flash (or two clickswill be heard) when
the code has been programmed.
Repeat the steps for programming additional remote controls or keyless
entry devices. Ifprogramming is unsuccessful, program the remote using
the learn button.
PIN
? ?
? ?
1
2
A
BC
3
DEF
4
GHI
5
JKL
6
MNO
7
P
RS
8
TUV
9
WXY
0
Q
Z
*
#
E
NT
E
R
0 QZ
*
#
ENTER
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON ONTHEGARAGEDOOROPENER
1 Locate the Learn button on the garage door opener. NOTE:Your garage
door opener may look different.
Learn
DE
L
Yellow
2
Locate the Program Button on the side of the remote control.
Program Button
Remote Control