Chamberlain AccessMaster M8856 - Remote Control; Program Using the Garage Door Opener

27
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
Older LiftMaster remote controls are NOTcompatible, see page 32 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructionsprovided with the accessory or visit
www.liftmaster.com.If your vehicle is equipped with a Homelink
®
, you may require an external adapter
depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE
DOOR CONTROL
1. Press the LEARNbutton on the door control to enter Programming Mode.
2. Press the LEARNbutton again, the LED will flash once.
3. Remote Control:
Press the button on the remote control thatyou wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then pressthe ENTER button.
The garage door opener lightswill flash (or two clickswill be heard) when the code hasbeen
programmed. Repeat the steps above for programming additional remote controls or keyless entry
devices. Ifprogramming isunsuccessful,program the remote using the learn button.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
MNO
3
PROGRAM USING THE GARAGE DOOR OPENER
1. Locate the Learn button on the garage door opener.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Press and hold the button the remote control thatyou wish to use.Release the button when
the garage door opener lights blink or two clicksare heard. Ifprogramming to other products,
press the button a second time to activate products.
LEARN LED
LEARN
Button
“click”
“click”
1-2
3
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately press and hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessory you wish to use.