Chamberlain LiftMaster ATS 2113X User Manual

Owner’s Manual
Please read this manual and the enclosed safety materials carefully! ■
Fasten the manual near the garage door after installation. ■
The door WILL NOT CLOSE unless the Protector System ■
®
is connected and
properly aligned.
Periodic checks of the opener are required to ensure safe operation. ■
The model number label is located on the front panel of your opener. ■
DO NOT exceed 8 complete cycles of door operation per hour. ■
The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.liftmaster.com
COMMERCIAL DOOR OPENER
Model ATS 2113X 1/2 HP
For Residential And Light Duty Commercial Use
Install on Sectional Doors Only
H
I
G
H
L
O
W
N
O
R
M
A
L
H
I
G
H
L
O
W
N
O
R
M
A
L
UP
FORCE
DOWN
FORCE
®

Chamberlain LiftMaster ATS 2113X Specifications

General

Model	ATS 2113X
Brand	Chamberlain LiftMaster
Drive Type	Chain Drive
Horsepower	1/2 HP
Frequency	60 Hz
Remote Controls Included	1
Safety Sensors	Yes
Battery Backup	No
Voltage	120V
Warranty	1 Year

Summary

Assembly

Attach Rail to Motor Unit

Attach Chain and Install Rail Support Bracket

Installation

Determine Header Bracket Location

Identifies the correct mounting point for the header bracket.

Install the Header Bracket

Secures the header bracket to the wall or ceiling structure.

Attach Rail to Header Bracket

Position and Hang the Opener

Install Door Control and Light

Attach Emergency Release Rope and Handle

Electrical Requirements

Install Safety Reversing Sensor System

Installs the crucial safety sensor system for obstruction detection.

Install Safety Sensor Brackets

Mount and Wire Safety Sensors

Connects and wires the safety reversing sensors to the opener.

Fasten Door Bracket

Connect Door Arm to Trolley

Adjustment

Adjust UP and DOWN Travel Limits

Sets the points where the door stops during opening and closing.

Adjust Force Settings

Regulates the power needed to move the garage door.

Test Safety Reversal System

Verifies the door reverses upon encountering an obstruction.

Test Protector System

Checks the functionality of the safety reversing sensors.

Operation

Troubleshooting

Having a Problem?

Addresses common issues like opener not operating or door reversing.

Programming

Remote Control and Keyless Entry Programming

Instructions for programming remote controls and keyless entry systems.

Keyless Entry PIN Management

Multi-Function Door Control Installation