EasyManua.ls Logo

Chamberlain CR625EVO - Wiring

Chamberlain CR625EVO
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
white
white/black
24 vdc
com
External
Receiver
Wired Wall Button
com
n/o
4 3 2 2 1
Obstruction Detection Beams
green (4) grey (3) white (2) red (1)
T
YPICAL WIRING DIAGRAM HANDYLIFT PLUS 2.0 (CR625EVO)
I
nformation for Service Personnel
20
Battery of the remote control:
The batteries in the remote have a long life.
If the transmission range decreases, the batteries should be replaced. Batteries are not covered by the warranty.
Replacing battery (CR2032 or equivalent):
To replace the battery, turn the remote control around
and open the case with a screwdriver. Lift the cover
and lift the control board. Slide the battery to one side
and remove the old battery. Be sure to observe the
polarity of the battery.
Assemble the transmitter again following the steps in
reverse.
REPLACE BATTERIES IN REMOTES
To prevent SERIOUS INJURY OR DEATH: observe the following instructions for the battery
- NEVER allow small children near batteries.
- If battery is swallowed, immediately notify a Doctor.
- Danger of explosion if battery is replaced improperly.
- Replacement only by identical or equivalent type.
- Dispose of old battery properly. Batteries should not be treated as household waste. All consumers
are required by law to dispose of batteries properly at the designated collection points.
- Never recharge batteries that are not meant to be recharged.
- Do not short-circuit batteries or take them apart.
- If necessary, clean contacts on batteries and contacts before loading.
- Never expose batteries to excessive heat such as sunshine, fire or the like!
21
or
1
2
V
D
C
Pb Cd Hg

Related product manuals