Chamberlain HD920EV User Manual

36
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control,remote control,wireless
keyless entry or MyQ
®
accessory.
When the door is closed and the garage door opener is activated the door will open. Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door is in any position other
than closed and the garage door opener is activated the door will close. If the garage door opener
sensesan obstruction while closing, the door will reverse.Ifthe obstruction interrupts the sensor beam
the garage door opener lights will blink 10 times.However,you can close the door if you hold the button
on the door control or keyless entryuntil the door is fully closed. The safetyreversing sensorsdo not
affectthe opening cycle.
The safetyreversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
Using the Motion Detecting Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener,press the push bar until the garage door
opener activates(it may take up to 3 presses).Test the door control by pressing the push bar, each press
of the push bar will activate the garage door opener.
ON (TTC)
OFF (TTC)
Command LED
Motion Sensor
Switch
LIGHT Button
HOLD OPEN
Button(TTC)
Motion Sensor
Push Bar
1, 5, and
10 Minute
TTC LED
LEARN Button
LOCK Button
MOTION DETECTINGCONTROLPANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHTbutton to turn the garage door opener lights on or off.When the lights are turned on
they will stay on until the LIGHTbutton is pressed again,or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn offafter the specified period of time (the
factorysetting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in motion.
To change the amount of time the garage dooropener lights will stay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener lightsflash.
The time interval is indicated by the number times the garage door opener flashes:
l
1 flash is 1-1/2 minutes
l
2 flashes is 2-1/2 minutes
l
3 flashes is 3-1/2 minutes
l
4 flashes is 4-1/2 minutes
To cycle through the time intervals repeatthe step above.
Light Feature
The lights will turn on when someone entersthrough the open garage door and the safetyreversing
sensor infrared beam is broken.
l
Deactivate: Press and hold the LIGHT button (approximately 10 seconds) until the garage
door opener lightsturn on,then off again.
l
Activate: Start with the garage door opener lights on.Press and hold the LIGHTbutton
(approximately 10 seconds) until the garage door opener lights turn off, then on again.
If the command LED is continuouslyblinking, the LOCK feature needs to be deactivated.

Chamberlain HD920EV Specifications

General

Brand	Chamberlain
Model	HD920EV
Category	Garage Door Opener
Language	English