Chamberlain HD920EV - Remote Control Operation; Programming Remote Controls (Motion Detecting); Programming Remote Controls (Smart Control Panel)

39
Operation
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
Older Chamberlain remote controlsare NOTcompatible,see page 44 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessoryor visit
www.chamberlain.com. Ifyour vehicle is equipped with a Homelink
®
, you may require an external
adapter depending on the make,model,and year of your vehicle.Visitwww.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MOTION-DETECTING CONTROL PANEL
1. Press the LEARNbutton on the door control to enter Programming Mode.
2. Press the LEARNbutton again, the LEDwill flash once.
3. Remote Control:
Press the button on the remote control thatyou wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) ofyour choice on the keyless entry
keypad.Then press the ENTERbutton.
The garage door opener lights will flash (or two clickswill be heard) when the code hasbeen
programmed.Repeat the steps for programming additional remote controls or keylessentry devices.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
Q
Z
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
M
NO
3
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE SMARTCONTROLPANEL
1. Press the navigation button below "MENU" to view the Features menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select "REMOTE"or "KEYPAD" to program from the program menu.
4. Remote Control:
Press the button on the remote control thatyou wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) ofyour choice on the keyless entry
keypad.Then press the ENTERbutton.
The garage door opener lights will flash (or two clickswill be heard) when the code hasbeen
programmed.Repeat the steps for programming additional remote controls or keylessentry devices.If
programming is unsuccessful, program the remote using the learn button.
Press to continue.
TO REMOTE
Press to continue.
1
2 3
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
MNO
4