Chamberlain WLED User Guide

7
Select Menu > Program > Remote and
follow the on screen prompts.
Programming
Remote Control
Below are the steps to program a new or existing
remote control. Test remote control before
reprogramming.
1. Press and release the LEARN
Button on the garage door
opener.
2. Press and hold the button on the
remote control that you wish to
use. Release the button when
the garage door opener lights
blink or two clicks are heard.
OR
If your vehicle is equipped with a Homelink
®
, you may
require an external adapter depending on the make,
model, and year of your vehicle.
Visit www.homelink.com for additional information.
Wireless Keyless Entry
Refer to the instructions provided with your
keyless entry OR go to LiftMaster.com to download
instructions.
To Erase the Memory
Erase ALL Remote Controls and Keyless Entries
Press and hold the LEARN button
until the LED goes out
(approximately 6 seconds).
All remote controls and
keyless entries are now erased.
Erase ALL Devices
(Including myQ enabled accessories)
1. Press and hold the LEARN button until the LED
goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button until
the LED goes out. All codes are now erased.
Erase the Wi-Fi Network from the
Garage Door Opener
Press and hold the adjustment
button until 3 beeps are heard
(approximately 6 seconds).
Erase a myQ Account
Go to myLiftMaster.com to delete your myQ account.
LEARN
Button
Adjustment Button

Chamberlain WLED Specifications

General

Brand	Chamberlain
Model	WLED
Category	Garage Door Opener
Language	English