81
P/N 115109 - Direct Vent Option Installation Instructions
Installing the Direct Vent Fan Electrical Control Box on the left-hand side
of the DH5000T (continued)
I
1/4-20
MOUNTING
BOLTS
J
MOUNTING
BRACKET
6. Locate the (4) 1/4-20 x 1/2" Hex
Head bolts on the upper left rear
side of the dishwasher directly
below the handle bracket.
(See Figure I).
7. Remove these bolts and set aside.
8. Carefully lift the electrical control
box and mounting bracket
assembly in place, align the
mounting holes and reinstall the
mounting bolts removed in Step 6
above. (See Figure J below).
9. Refer to Figure G on the previous
page and note that a 12 ft. [3.7 m]
vent fan cable has been prewired
to the control box for the 120VAC
Champion supplied vent fan.
Route this cable from the control
box to the vent fan in accordance
with all local codes and regulations
to complete the installation.
Electrical Connections For the
Optional Champion
Supplied Vent Fan on Next Page.
! ATTENTION !
The Direct Vent Fan Control box can be wall-mounted using a Wall Mount Kit, P/N 900958.
See the last page of this manual for further instructions.
To Next Page
Loading...
Need help?
General
