ChamSys QuickQ Series Service Document

ChamSys QuickQ Series Service Document
Page 10 of 17 www.chamsys.co.uk
To remove the encoder PCBs: Each of these PCBs is secured in place with 2x M3x6
screws and shake-proof washers, removable with a PZ1 screwdriver. Each PCB is also
connected by one cable, which can be disconnected at either end by pulling with light
force, while wiggling the connector until it comes free. Note that the cable for the left-
hand encoder PCB (when looking from the underside of the front panel) is secured to a
spacer with a cable tie – see the left picture, below. This can be slid off or cut.
To remove the playback fader PCB: First, disconnect the touch screen ribbon cable,
highlighted in the picture below, right. You will also need to disconnect the cables to the
encoder PCB and the preset fader PCB if you have not already done so. Once all cables
are disconnected, remove the 4x M3x6 screws and shake-proof washers using a PZ1
screwdriver, and the 4x spacers using a 5.5mm nut driver or adjustable spanner (all
highlighted in the left picture below). The panel should then be free to be removed.

ChamSys QuickQ Series Specifications

General

Ethernet Ports	1
USB Ports	2
Motorized Faders	No
MIDI I/O	Yes
Built-in Effects	Yes
DMX Channels	512
Universes	1
Screen	Touchscreen
Physical DMX Outputs	1
Software	QuickQ Software