100-00-9 Overview 100-00-9
Description and Operation (Continued)
The electric wire of electric appliance shall be
ensured not to be intercepted or damaged when the
automobile is hoisted.
Ensure that the electrician be trained in first aid.
If electrically shocked:
– Cut off the power source before touching the
electric shocker.
– If the power source can not be cut off, use the
dry and non conducting materials to push away
the sufferer or draw the sufferer away the
power source.
– Perform the cardio-pulmonary resuscitation
immediately.
– Seek the medical help.
Engine Oil
Please see Section Lubricating Oil and Grease.
Waste Gas
The waste gas includes the noxious, harmful
and smothering chemical materials, such as
carbon monoxide, nitrogen monoxide,
acetaldehyde, aromatic hydrocarbon and lead
containing gas, etc. The engine can only be
started after the waste gas is discharged or in
the places of air circulation.
Gasoline Engine
The gasoline engine has no symptom before
generating the noxious and harmful gas. The harm
of the noxious and harmful gas can be immediate
and also can be latent.
Acoustic Insulation Fiber
See Section Dust.
The acoustic insulation fiber is used for insulating
the sound and the noise.
The cellulose and the cutting scrap will cause the
skin stimulation. This is often the physical effect
but not the chemical reaction.
The working practice guide must be complied, and
the gloves must be worn to avoid the substance
contacting with the skin for a long time.
Fire Prevention
See Welding, Foam and Legal Affairs.
Most of the substances related to the automobile
maintenance are the inflammable substances. The
noxious or harmful gas can be released when some
of them are burnt.
When the inflammable substances or the melting
agents are stored or used, especially when welding
or being close to the electrical equipment, the fire
safety shall be strictly noted.
Before using the welding device or the heating
device is used, ensure that there are no
combustibles around, and place the extinguisher
nearby.
First Aid
Besides meeting the legal requirements, the
maintenance workshop must be equipped with the
personnel who have been trained for first aid.
After any substance is sprayed in eyes, the eyes
must be washed for at least ten minutes with clean
water.
After polluted by the chemical substance, the skin
shall be washed with water and the toilet soap.
Wash and cool with cold water immediately after
burnt by some substances.
If inhale the dust, go to the places with fresh air
immediately. If this method does not take effect,
please send to the hospital immediately.
If drink some liquid for carelessness, please go to
hospital immediately and say the name and
composition of the liquid. Do not try to vomit
unless there has special instruction on the label.
Foam - polyurethane
See Section Fire Prevention.
The foam is used for isolating the sound and the
noise. There are also foams in the seat and the
shock absorber.
Operate by strictly following the instruction book
of the manufacturer.
The unreacted components have irritability and will
cause damage to skin and eyes. Please wear gloves
and the protective glasses.
The person suffering from the chronical respiratory
system diseases, asthma and bronchitis or person
To Next Page
