100-00-15 G
eneral Introduction
100-00-15
Instruction and Operation
Standard Workshop Operating Manual
Automobile in Maintenance Workshop
When the automobile in the maintenance workshop
is maintained, the following items shall be ensured:
– Apply parking brake or fix the wheel in order to
avoid the automobile moving forward and
backward.
– Take off the ignition key during the front
operation of the automobile.
– If the automobile engine will be started, ensure
that the field ventilation is good, or exhaust the
waste gas with the waste gas centralized
exhausting pipe.
– Enough space should be needed to hoist the
automobile for replacing the tyres if necessary.
– The fender flap pad should be provided during
the maintenance in the engine compartment.
– Firstly cut off the power source of battery when
the engine is maintained or the maintenance or
automobile hoisting is performed at the vehicle
base.
Warning: firstly cut off the generator
wiring harness when the arc welding of the
automobile are performed in order to avoid
possible and excessively strong current which
may damage the generator internal
components.
If the welding device is used in the automobile,
the extinguisher should be placed nearby.
Traction Automobile
Warnings: During the traction process of
the automobile, the ignition switch of automobile
must at the position II. (Open the steering lock
and start the indicating lamp), and thus the
steering lamp, the loudspeaker and the brake
lamp can operate normally; otherwise, the
personal injury can be caused.
Notes: The movable towing hook is provided with
a left rotating thread, and the left rotating thread
must be screwed completely before the traction
automobile. When the traction automobile is
required, the traction hook shall be adopted. The
hook must be fastened firmly through the traction
rope, and the traction rope must be connected on
the other automobile, to avoid the vehicle body
entangled with the rope.
When the automatic speed-changing automobile is
dragged, the gear position must be at the N position.
The pulling speed of the automatic speed-changing
automobile can not exceed 50 km/h or the trailer
car distance can not exceed 50 km. If the distance
of the traction automobile must be ultra-long, the
driving wheels must lift off completely.
The automobile can be transported through the
trailer car with the low boarding or the traction
automobile.
Connect the auxiliary battery through the
jumper wire
Warnings: If the auxiliary battery has been
charged and processed with gas, during
connecting with the jumper wire, the upper
ventilator of the plug or the wet clothing cover
shall be adopted, thus the explosive hazard
caused by the ignition of the electrical arc is
reduced during connecting with the jumper wire.
If the operation is not achieved according to the
procedures, the personal injury can be caused.
Warnings: The battery can be discharged
due to the current short circuit, and if the
electric discharge phenomenon exists, the
energized circuit still exists in the automobile
after the normal circuit is cut off. When the
jumper wire is connected, the casing of the
battery can be distorted.
Warnings: When the vehicle is not
required to jump and start, it can be
considered as the only feasible method to start
the vehicle if necessary. On this condition, the
discharged battery must be charged
immediately again after jumping and starting,
to avoid the permanent damage.
– Check whether the jumper wire can bear load,
and use the heavy-load conducting wire.
– Ensure that the auxiliary battery shall have the
identical voltage with the vehicle battery. Two
batteries must be connected.
– Before the jumper wire is connected, check
whether the circuit of available switch control is
cut off. Thus, when the final connection is
performed, the danger of electrical arc generated
can be reduced.
To Next Page
