202-01-20 Driving Axle 202-01-20
DISASSEMBLING AND INSTALLATION (Continued)
长安·奔奔MINI
• Material: aluminum plate or steel plate
5. Well install the universal joint of the driving
axle and fix the universal joint of the driving
axle with a new nip.
• Use the special tool to clip the head of the nip.
• Install the nip.
Notes: The fixing torque of the 0.8mm nip is 12Nm and
the fixing torque of the 1.1mm nip is 20Nm.
• Use the special tool to fix the nip.
6．Install wheel hub fixing nuts and washers, and
insert the locking pin. Fix the tyre nuts（The
torque is 85±10Nm）and the hub faxing nuts
（The torque is200±10 Nm）.
7. Install the front oscillating arm in the steering
knuckle.
8.
8. Install the wheel and tyre. See Section 201-03 for
relevant information.
To Next Page
Loading...
