To Next PageTo Next PageHow to stop flare-ups on my Char-Broil Grill?
Flare-ups on your Char-Broil grill can be caused by grease buildup, excessive fat in the meat, or excessive cooking temperature. To resolve this, clean the burners and inside of the grill/firebox, trim fat from meat before grilling, and adjust (lower) the cooking temperature.
Why is the flame so low on my Char-Broil 463644220N Grill?
A sudden drop in gas flow or low flame on your Char-Broil grill can occur if you are out of gas, the excess flow valve has tripped, or there is a vapor lock at the coupling nut/LP cylinder connection. Check for gas in the LP cylinder. If the excess flow valve tripped, turn off the knobs, wait 30 seconds, and light the grill. If flames are still low, turn off knobs and the LP cylinder valve, disconnect the regulator, reconnect the regulator and leak-test, turn on the LP cylinder valve, wait 30 seconds, and then light the grill. If there is a vapor lock, turn off the knobs and LP cylinder valve, disconnect the coupling nut from the cylinder, reconnect, and retry.
What to do if flames blow out on Char-Broil 463644220N?
If the flames on your Char-Broil grill blow out, it could be due to high or gusting winds, or low LP gas. Turn the front of the grill to face the wind or increase the flame height by turning the gas valve to a higher position. If the LP gas is low, refill the LP cylinder. It's also possible that the excess flow valve tripped; in this case, refer to the troubleshooting steps for a sudden drop in gas flow.
How to handle a grease fire on a Char-Broil Grill?
If you have a persistent grease fire on your Char-Broil grill, this may be due to grease trapped by food buildup around the burner system. Turn the knobs to OFF and turn the gas off at the LP cylinder. Leave the lid in position and let the fire burn out. After the grill cools, remove and clean all parts.
Why are the sparks weak on my Char-Broil 463644220N?
If sparks are present but not at all electrodes and/or not at full strength on your Char-Broil grill, it could be due to output lead connections not connected, arcing to the grill away from the burner(s), a weak battery, wet electrodes or cracked electrodes. Remove and reconnect all output connections at the module and electrodes. If possible, observe the grill in a dark location, operate the ignition system, and look for arcing between output wires and the grill frame. Replace the battery with a new alkaline battery. Use a paper towel to remove moisture from the electrodes. Replace cracked or broken electrodes.
What causes fire in burner tubes of Char-Broil 463644220N?
A flashback (fire in burner tubes) in your Char-Broil grill means the burner and/or burner tubes are blocked. Turn the knobs to OFF and clean the burner and/or burner tubes. Refer to the burner cleaning section of the Use and Care guide for detailed instructions.
What if my Char-Broil 463644220N Grill makes noise but doesn't spark?
If no sparks appear at any electrodes when the Electronic Ignition Button is pressed, but noise can be heard from the spark module of your Char-Broil grill, the output lead connections may not be connected. Remove and reconnect all output connections at the module and electrodes.
General| Brand | Char-Broil |
|---|---|
| Model | 463644220N |
| Type | Gas Grill |
| Fuel Type | Propane |
| Burners | 4 |
| Material | Stainless Steel |
| Side Burner BTUs | 10, 000 BTUs |
| Ignition System | Electronic |
Explains the meaning of Caution, Warning, and Danger symbols used in the manual.
Provides procedures for gas leak detection and rules for storing flammable liquids.
Covers repair restrictions, flame out procedures, and grate covering rules.
Covers instruction adherence, pot limits, sharp edges, and pre-assembly review.
Explains how to handle and prevent grease fires by proper cleaning.
Procedures for removal, transport, and safe storage of LP cylinders.
Requirements for cylinder size, DOT/CSA marking, and valve type (OPD).
Information on LP gas odor, flammability, and safe filling practices.
Guidance on using reputable exchange services and inspecting cylinders.
Detailed steps for safely testing LP cylinders for leaks before use.
Step-by-step instructions for securely attaching the regulator.
Procedure for performing a leak test on connected components.
Tips on operation, hot surfaces, sideburner limits, and cleaning.
Notes on choking hazards and battery precautions.
Importance and procedure for checking the cylinder valve's rubber seal.
Rules for safe use, ventilation, clearance, and lighting.
Specific considerations for residents in apartment complexes.
Steps for lighting main burners using the electronic ignitor.
Instructions for lighting the sideburner using ignitor or match.
Detailed steps for lighting main burners using a match.
Procedures for flame, ignitor, valve, and hose checks.
Instructions for proper storage of the grill.
Information on preventing burner obstructions and flashbacks.
Methods for cleaning various grill surfaces and parts.
Steps for activating the grill's self-cleaning feature.
Detailed instructions for cleaning or replacing burner components.
Details on what parts are covered and for how long.
Lists items and conditions not covered by the warranty.
Explains limitations on implied warranties and manufacturer liability.
Steps to take if a gas leak occurs and cannot be stopped.
Diagnosing and resolving problems related to gas flow and ignition.
Addressing issues with ignition system components like electrodes and batteries.
Solutions for low flame, blow-outs, flashbacks, and persistent fires.
Detailed troubleshooting for ignition system failures, including spark issues.
Instructions for registering the product via the Char-Broil website.
Instructions for registering the product by returning a form.
