To Next PageTo Next PageHow to stop flare-ups on my Char-Broil 463672416?
To address flare-ups on your Char-Broil Grill: * Clean the burners and the inside of the grill/firebox. * Trim fat from meat before grilling. * Adjust the temperature to a lower setting as needed.
What to do if my Char-Broil 463672416 has a sudden drop in gas flow?
If you experience a sudden drop in gas flow or low flame on your Char-Broil Grill: 1. Check for gas in the LP cylinder. 2. Turn off the knobs, wait 30 seconds, and light the grill. If flames are still low, turn off the knobs and LP cylinder valve, disconnect the regulator, reconnect the regulator and leak-test, turn on the LP cylinder valve, wait 30 seconds, and then light the grill. 3. Turn off the knobs and LP cylinder valve, disconnect the coupling nut from the cylinder, reconnect, and retry.
How to fix weak sparks on Char-Broil 463672416 Grill electrodes?
If sparks are present but not at all electrodes, or not at full strength on your Char-Broil Grill: * Remove and reconnect all output connections at the module and electrodes. * If possible, observe the grill in a dark location. Operate the ignition system and look for arcing between output wires and the grill frame. * Replace the battery with a new alkaline battery. * Use a paper towel to remove moisture from the electrodes. * Replace cracked or broken electrodes.
How to troubleshoot Char-Broil 463672416 Grill when there are no sparks?
If no sparks appear at any electrodes when the Electronic Ignition Button is pressed and no noise can be heard from the spark module on your Char-Broil Grill: * Install the battery properly, ensuring that the '+' and '-' connectors are oriented correctly, with '+' on the cap end. * Replace the battery with a new alkaline battery. * Unscrew the button cap assembly and reinstall, making sure the threads are aligned and engaged fully. * Replace the spark module assembly.
What to do if Char-Broil 463672416 Grill spark module makes noise but no spark?
If no sparks appear at any electrodes when the Electronic Ignition Button is pressed, but noise can be heard from the spark module on your Char-Broil Grill, remove and reconnect all output connections at the module and electrodes.
How to fix a Char-Broil Grill burner that won't light?
If one burner does not light from other burners on your Char-Broil Grill, it's likely due to grease buildup or food particles in the end(s) of the carryover tube(s). Clean the carry-over tube(s) with a wire brush.
Why do the flames keep blowing out on my Char-Broil Grill?
If the flames on your Char-Broil Grill are blowing out, try the following: * Turn the front of the grill to face the wind or increase the flame height by turning the gas valve to a higher position. * Refill the LP cylinder. * Refer to the troubleshooting steps for 'Sudden drop in gas flow'.
What to do if my Char-Broil 463672416 Grill has a persistent grease fire?
If your Char-Broil Grill has a persistent grease fire: Turn the knobs to OFF, turn the gas off at the LP cylinder, leave the lid in position, and let the fire burn out. After the grill cools, remove and clean all parts.
Why is there a fire in the burner tubes of my Char-Broil Grill?
If you experience a flashback (fire in burner tubes) on your Char-Broil Grill, it is because the burner and/or burner tubes are blocked. To resolve this, turn the knobs to OFF and clean the burner and/or burner tubes. Refer to the burner cleaning section of the Use and Care guide for detailed instructions.
General| Brand | Char-Broil |
|---|---|
| Model | 463672416 |
| Category | Grill |
| Language | English |
Defines CAUTION, WARNING, DANGER symbols used in the manual.
Procedures for managing and extinguishing grease fires.
Warning regarding chemical exposure and health risks.
Rules and codes for safe grill setup.
Safe practices for LP cylinders, including removal and storage.
Service options for cylinders and safety checks.
Step-by-step guide for attaching the regulator.
Specific instructions for leak testing components.
Advice for safe operation and usage.
Key safety rules to follow before igniting the grill.
How to use the electronic ignitor to light the grill.
How to safely ignite the grill using a match.
Procedures for checking key grill components.
Instructions for properly storing the grill.
Addressing burner obstructions caused by spiders or debris.
Cleaning various grill parts and surfaces.
Instructions for building the grill.
Immediate actions for gas leaks and fires.
Troubleshooting ignition failures for burners.
Resolving problems with gas flow and flame performance.
Diagnosing faults within the electronic ignition system.
