15
EN
3. Instructions for use
To start the treatment press “Quick start”, choose the emission mode
(continuous, interrupted, etc), set power parameter by pressing “Laser
power” and energy quantity by pressing “Joule”, take out the handpiece
from its holder, put on the handpiece spacer and press the footswitch to
activate laser emission. The handpiece must always be held perpendicular
to the patient; you can increase or decrease the power by turning the knob
clockwise / counter-clockwise.
The lower part of the screen shows the actual power delivered, the time, the
amount of energy transferred and the temperature of the laser head.
3.1 Start-up
After the device is switched on and the welcome screen has appeared, you
will come to the main ‘device management’ screen, and will need to enter
the password.
To Next Page
Loading...
