Appliance Date and Time Settings
Quantum Spark 1535 / 1555 Appliance Getting Started Guide|24
Appliance Date and Time Settings
In the Appliance Date and Time Settings page, configure the appliance's date, time, and time zone settings
manually or use the Network Time Protocol option.
If you select the option Set the time manually, the appliance uses the date and time from your computer as
the initial values. If necessary, change the time zone setting to show your correct location. Daylight Savings
Time is automatically enabled by default. You can change this in the WebUI application on the Device >
Date and Time page.
n
Date - The date on your computer appears by default. If required, set a different date.
n
Time - The time on your computer appears by default. If required, set a different time.
n
Time Zone - The time zone on your computer appears by default. If required, select a time zone
setting to reflect your exact location.
n
Primary NTP server - The IP or host name of the primary NTP server. The default server is
ntp.checkpoint.com
n
Secondary NTP server - The IP or host name of the secondary NTP server. The default server is
ntp2.checkpoint.com
To Next Page
Loading...
