Check Point Smart-1 225 - Appliance Hardware Diagnostic Tool; Restoring Factory Defaults; Running the Diagnostic Tool

Hardware Diagnostic Tool and Restoring Factory Defaults
56 | Smart-1 225/3050/3150 Appliances Getting Started Guide
Appliance Hardware Diagnostic Tool
Use the Appliance Hardware Diagnostic Tool (Diagnostic Tool) to make sure that the
appliance hardware is working properly and complies with the appliance
specifications.
Restoring Factory Defaults
If necessary, restore the appliance to its factory default settings or select a new
image.
Important - If you restore factory defaults or select a new image, all
information on the appliance is deleted.
Running the Diagnostic Tool
You can run the Diagnostic Tool from LCD panel, or connect to the Console port with a
Terminal emulation program. For more about the Diagnostic Tool, see sk97251
http://supportcontent.checkpoint.com/solutions?id=sk97251.
To Run the Diagnostic Tool from the Console boot menu
1.
Connect the supplied DB9 serial cable to the console port on the front of the
appliance.
2.
Connect to the appliance using a terminal emulation program such as Microsoft
HyperTerminal or PuTTY.
a) Configure the terminal emulation program:
 In the HyperTerminal Connect To window, select a port from the Connect
using list.
 In PuTTY select the Serial connection type.
b) Define the serial port settings: 9600 BPS, 8 bits, no parity, 1 stop bit.
c) From the Flow control list, select None.
3.
Reboot or turn on the appliance.
4.
When this message shows, hit any key to activate the Boot menu. You have about
four seconds.
Press any key to see the boot menu [Booting in 5 seconds]