Check Point Smart-1 50 - Customer Replaceable Parts

Customer Replaceable Parts
Smart-1 Hardware Page 34
Menu Options
Menu
Sub-menu
Purpose
Network
Set MGMT IP
Set the management interface's IP
address
Set Netmask
Set the management interface's
network mask
Set Default GW
Set the management interface's
default gateway
System
Reboot
Reboot the appliance
When Entering an IP Address
To
Press
Move to the next digit
Move back to the previous
digit
Approve the change
when cursor is located on the last digit
Cancel the IP change
when cursor is located on the first digit
Change current digit
or
Customer Replaceable Parts
To ensure maximum availability and ease of maintenance, the Smart-1 appliance contains the following
customer replaceable parts:
 Smart-1 50:
 Two power supplies
 Four hard disk drives
 Two cooling fans
 Smart-1 150:
 Three power supplies
 Up to twelve hard disk drives
 Three cooling fans
Unless directed to do so by Check Point technical support, customers are prohibited by warranty and
support agreements from replacing any parts. Customers are prohibited from opening the Smart-1 case
under any circumstances.
Power Supplies
This section presents the procedures for removing and installing a power supply unit. It is not necessary to
power off the appliance before adding or removing a power supply.