• During USB play, Press and hold to select one repeat, all repeat, shufe or off
repeat mode.
6.7 Set display brightness
You can press DIM repeatedly to select a different brightness level of the display panel on
this product.
6.8 Auto standby
When playing media from a connected device, the product automatically switches to
standby after 15 minutes if no audio/video signal is received from a connected device.
6.9 Apply factory settings
You can reset this product to the default settings programmed at the factory.
1 Press repeatedly SOURCE on the remote control, until the AUX on the display
panel. In AUX IN mode, on the remote control press VOL -, BASS, and TREBLE in
sequence within three seconds.
» When the factory setting restore is complete, the system shuts down into standby
mode and restart.
Note
• This product may not be compatible with certain types of USB storage device.
• Digital camera PTP and MTP protocols are not supported.
• Do not remove the USB storage device while it is being read.
• DRM-protected music les (MP3, WMA) are not supported.
• Support a USB port: 5V , 1A.
MODEL#: W100-41 Page 17 of 19
To Next Page
Loading...