20
SETTING THE FIRST REMOTE CONTROL
PROGRAMMING TO SERIES SKIPPER - SERIES GIRO -
SERIES POP REMOTE CONTROLS
This operation can only be performed when the receiver is new, or
after a total delete of the memory. The operation can be performed
in two ways:
T1: First remote control to be set
T1 short
T1 short
T1 short
T1 short
T1 (2 sec) long
(2 sec) long
+
A B
B B
+
A B
B
SETTING OF ADDITIONAL REMOTE CONTROLS
Up to 15 remote controls can be set.
Tn: Already programmed remote control
Tx: Additional remote control
Every time you connect the control unit you have 3 hours to store
the rst remote control. After this time, the ability to store the
remote control is disabled. To reset the timer of the function you
have to disconnect and reconnect the control unit.
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
Tn short Tn short
Tx (2 sec) long
+
A B
B B
GB
To Next Page
Loading...