10-62 Vehicle Care
Do not remove any objects that
have penetrated the tire.
1. Remove the tire sealant canister
and compressor from its storage
location. See Storing the Tire
Sealant and Compressor Kit on
page 10‑67.
2. Remove the air only hose (J)
and the power plug (I) from the
bottom of the compressor.
3. Place the compressor on the
ground near the flat tire.
4. Attach the air only hose (J) to
the sealant canister inlet
valve (A) by turning it clockwise
until tight.
5. Slide the base of the tire sealant
canister (C) into the slot on the
top of the compressor (F) to hold
it upright.
Make sure the tire valve stem is
positioned close to the ground
so the hose will reach it.
6. Remove the valve stem cap from
the flat tire by turning it
counterclockwise.
To Next Page
