Chevrolet Spark - Top-Tether Fastening Eyes

Seats, restraints 53
Caution
Full size rear facing child seats
may not be suitable for installation.
Contact your Retailer for
information regarding suitable
child restraint systems.
Installation of child restraints with
ISOFIX low and Top-tether
anchorage attachments.
Top-tether fastening eyes
To access the Top-tether anchor
points, do the following:
1. Remove the load compartment
cover.
2. Attach the clip on the child
restraint's tether strap to the
Top-tether anchor, making sure to
remove any twists in the tether
strap.
If the position you are using has
an adjustable head restraint and
you are using a dual tether, route
the tether around the head
restraint.
If the position you are using has
an adjustable head restraint and
you are using a single tether, raise
the head restraint and route the
tether under the head restraint
and in between the head restraint
posts.
3. Tighten the child restraint's tether
strap according to the instructions
supplied with the child restraint.
4. Push and pull on the child restraint
after installation to be sure the
child restraint is secure.
9
Warning
Make sure the clip on the child
restraint's tether strap is properly
attached to the Top-tether
anchorage.
Incorrect attachment could render
the tether strap and top tether
anchorage ineffective.