72 Instruments and controls
Control indicators in the centre
console
Turn signal
O flashes green.
Flashes
The control indicator flashes if a turn
signal or the hazard warning flashers
are activated.
Rapid flashing: failure of a turn signal
light or associated fuse.
Bulb replacement 3 181, Fuses
3 186, Turn signals 3 83.
Seat belt reminder
Seat belt reminder on front
seats
X for driver's seat illuminates or
flashes red.
k for front passenger seat illuminates
or flashes red, when seat is occupied.
1. After the ignition has been
switched ON, the control indicator
illuminates until the seat belt is
fastened.
2. After the engine is running, the
control indicator flashes for
100 seconds and then illuminates
until the seat belt is fastened.
3. If the vehicle moves more than
250 m or the speed is over
22 km/h with unfastened seat belt,
the control indicator will flash and
the chime will sound for
100 seconds.
After 100 seconds, the indicator will
illuminate until the seat belt is
fastened, and the chime will go off.
Seat belt status on rear seats
X for rear seats illuminates or flashes
red.
1. When engine is running with all
doors closed and the vehicle
speed is less than 10 km/h, the
rear seat belt indicators illuminate
until the belts are fastened. In
case that nobody occupies on the
seats, this behaviour is still
applied.
2. If the vehicle speed is over
10 km/h with all doors closed,
unfastened rear seat belt
indicators will illuminate for
35 seconds and go off regardless
of occupancy of the rear seats. If
a rear seat belt becomes
fastened, the other unfastened
belt indicator will illuminate again
for 35 seconds and go off.
3. If any rear seat belt status
changes from fastened to
unfastened when the vehicle
speed is over 10 km/h and all
doors closed, the belt indicator will
flash until the seat belt is fastened
and a chime will sound 4 times.
To Next Page
Loading...
