64 Instruments and controls
the CLOCK button. The setting will be
finished without any operation a few
seconds after adjusting.
<Type 2>
Press MENU button until the lower
display area flashes.
Press the SET/CLR button for more
than 2 seconds and then it shifts into
the setting mode.
When the hour display flashes, select
the hour by using the { or } button
(if the hour display flashes without
any operation for more than
30 seconds, the time will return to the
setting mode entry time)
Press SET/CLR button after selecting
the hour and then the minute display
is flashing.
Select the minute by using the
{ or } button (if the minute display
flashes without any operation for
more than 30 seconds, the time will
return to the setting mode entry time).
Press the SET/CLR button after the
minute setting is completed.
Power outlets
Type 1
Type 2
A 12 Volt power outlet is located in the
front console.
Do not exceed the maximum power
consumption of 120 Watts.
With ignition off, the power outlets are
deactivated.
Additionally the power outlets are
deactivated in the event of low battery
voltage.
Do not connect any current-delivering
accessories, e.g. electrical charging
devices or batteries.
Do not damage the outlet by using
unsuitable plugs.
To Next Page
Loading...
