Installation Instructions AVSFSS
5
Assembly And Installation
NOTE: For large-scale installations, component storage
panels (A) may be removed from each box and pre-
loaded with components prior to AVSFSS installation.
Stand Assembly
1. Determine distance desired from finished floor to center of
display.
2. Refer to chart below to determine holes to use to assemble
uprights (B and G).
3. Use four 1/4-20 x 1/2" Phillips tapping screws (S) to secure
top uprights (B) to buttom uprights (G). (See Figure 1)
Figure 1
4. Use two 1/4-20 x 1/2" Phillips flathead screws (U) to secure
long spacer bracket (H) and short spacer bracket (J) to top
uprights (B). (See Figure 2)
5. Use 1/4-20 x 1" Phillips pan machine screw (D) to secure
long spacer bracket (H) and short spacer bracket (J)
together. (See Figure 2)
Figure 2
WITH RXF2/RLF2/RMF2 HOLE NUMBERS
68.4" (173.7cm) from floor
1, 6
67.4" (171.2cm) from floor
2, 7
66.4" (168.6cm) from floor
3, 8
65.4" (166.1cm) from floor
4, 9
64.4" (163.5cm) from floor
5, 10
63.4" (161cm) from floor
6, 11
62.4" (158.5cm) from floor
7, 12
61.4" (156cm) from floor
8, 13
60.4" (153.4cm) from floor
9, 14
59.4" (150.9cm) from floor
10, 15
58.4" (148.3cm) from floor
11, 16
57.4" (145.8cm) from floor
12, 17
56.4" (143.2cm) from floor
13, 18
55.4" (140.7cm) from floor
14, 19
54.4" (138.1cm) from floor
15, 20
WITH LTM1U/MTM1U/LSM1U/
MSM1U
HOLE NUMBERS
65.6" (166.6cm) from floor
1 and 6
64.6" (164cm) from floor
2 and 7
63.6" (161.5cm) from floor
3 and 8
62.6" (159cm) from floor
4 and 9
61.6" (156.5cm) from floor
5 and 10
60.6" (153.9cm) from floor
6 and 11
59.6" (151.4cm) from floor
7 and 12
58.6" (148.8cm) from floor
8 and 13
57.6" (146.3cm) from floor
9 and 14
56.6" (143.7cm) from floor
10 and 15
55.6" (141.2cm) from floor
11 and 16
54.6" (138.7cm) from floor
12 and 17
53.6" (136.1cm) from floor
13 and 18
52.6" (133.6cm) from floor
14 and 19
51.6" (131.1cm) from floor
15 and 20
3
(S) x 4
(G) x 2
(B) x 2
(U) x 2
4
(D)
5
(H)
(J)
(B) x 2
To Next Page
Loading...
