Fix the wall-mounting plate according to the selected position of indoor unit
and the route of the pipe.
Firstly, use a steel nail to fix the wall-mounting plate onto the wall. Level it
with the level gauge and then fix tightly.
Note: When installing the models with additional functions (purification
device), we shall take the position of this device into consideration for the
distance to the ceiling.
Select the position of wall-cross hole according to the position of
wall-mounting plate.
Selection of piping mode: Try not to choose the mode of right exit-pipe so as
to ensure the orderliness and smoothness of the pipe.
1. Route the pipe directly along the right side of the machine body. 2. Route
the pipe directly on the rear. When bending the pipe, please support the elbow
with your right hand and then use your left hand to rotate slightly for 90°
before stop. 3. Route the pipe along the left side. This step is the same as the
above step. The only difference is that the bending angle is higher than that in
the previous step, that is, it should be bent to 180°. Take care to rotate this
angle slightly and slowly; Otherwise the pipe would be flattened easily . Then,
drill a hole (shuld be a little larger than the outer diameter of the wall-cross
tube so as to ensure the wall-cross rube can be inserted through). Caution: For
easy drainage of the water out of the internal unit, the indoor unit shall be
mounted slightly higher than the wall-cross hole. Meanwhile, the wall-cross
hole must be inclined outward down.
Hang the indoor unit onto the clamp of the wall-mounting plate. Move the
body of indoor unit left and right, and check if it is fixed tight.
To Next Page
Loading...
Need help?
General
