Chikusui Canycom CM 221

Questions and Answers

R
Richard HernandezAug 26, 2025
Why is my Chikusui Canycom Brush Cutter difficult to start?
- E
  Elizabeth SchneiderAug 27, 2025
  If you're experiencing difficulty starting your Chikusui Canycom Brush Cutter, there are several potential causes. Ensure you have enough fuel. If there's air or water in the fuel, check the pipe and tightening band, and repair or replace if necessary. Avoid excessive fuel intake by allowing an interval before starting. Check if the engine oil is too low or of poor quality; replenish or replace it. Clean or replace the spark plug if it's dirty or sparking poorly. Ensure the battery has sufficient capacity by replenishing the battery fluid. Finally, if there are impurities in the fuel circuit, charge the battery and consider replacing the fuel filter.
D
djonesAug 25, 2025
What to do if Chikusui Canycom Brush Cutter engine stops abruptly?
- K
  Kara DorseyAug 26, 2025
  If your Chikusui Canycom Brush Cutter engine stops abruptly, it could be due to a lack of fuel. Add fuel to resolve this. Alternatively, it might be burning due to insufficient or deteriorated engine oil. In this case, check the oil level and add oil as needed.
J
Jimmy MoyerAug 25, 2025
Why Chikusui Canycom Brush Cutter produces excessive black smoke?
- C
  Christopher PetersAug 25, 2025
  If your Chikusui Canycom Brush Cutter is emitting excessive black smoke, it could be due to several reasons. First, ensure the choke is fully open. If not, move the choke to the FULL position. It could also be caused by poor compression, in which case you should consult a dealer. Other potential causes include a clogged air cleaner (clean or replace it), excessive oil intake (adjust oil volume), or poor fuel quality (replace the fuel).