Wet or dry cutting is possible. Cutting wet will extend the life of your diamond blades. A
ater attachment comes as standard equipment with the EHS350C. Before using the
is tightened.
Always install the blade so that the arrow on the blade points in direction of the rotation of
efore carrying or transporting your cut-off machine the engine must be off. Never leave
gonal
d correct if necessary.
art and operate this saw without
w
water attachment make sure that the screw that secures the outlet tube
the spindle.
B
the engine running whilst unattended, e.g. on the ground.
Proper tension of the V-belt is important. In order to avoid a false setting, the tensioning
rocedure must be followed as described in your manual. Always make sure the hexa
12
p
collar nuts for the cast arm are tightened securely. Check V-belt tension after one hour of
operation an
3. Operator:
. The cut-off saw is a one–person tool. So st
To Next Page
Loading...