. To stop or halt the cut (when a cut is c runs out of fuel halfway,
n release the throttle
4. E
. However, if a malfunction or
im
fr
of y be adversely affected if
the engine is stopped too often during cutting.
ompleted, or the engine
out of the cut, theor abnormal sound is heard), first lift the blade
trigger, wait until the engine slows down to idle speed and the blade stops running,
then finally turn off the machine.
mergency stopping (Ref. Fig.8)
Under normal conditions, the machine is to be turned off
when the engine idles
30
emergency occurs during cutting, you can stop the engine
mediately by pressing and holding the kill switch (2) on the
ont end of the rear handle (1). But note that the service life
some components of the saw ma
Fig. 8
To Next Page
Loading...