● Loosen and unscrew the hexa box and then
remove transmission box cover (2).
● Loosen the three hexago plate.
● Turn the tensioning nut (6) clockwise (3) clockwise)
until the V-belt is tension
● Tighten the three hexago
2. Sta n
. Place
sure it’s
the w
. Press the button of t
. Set the choke lever (2) to an appropriate position:
gon bolts (1) on the transmission
n bolts (5) on the bearing
(or turn the adjusting bolt
ed.
n bolts ( 5) on the bearing plate.
(2) and fit and tighten the hexagon bolts (1).
g (Ref. Fig.7)
● Fit the transmission box cover
Fig. 6
rti
the cut-off saw on the ground and make
26
in good balance, see to it that the saw
blade does not touch any objects or the ground,
and there is no person within the swivel range of
sa .
he decompression valve (1).
To Next Page
Loading...